Team 1261

It is time to start working/planning again.

We can work 3 hours Wed night from 6-9pm with 5 team members, 1 mentor plus 5 students.

My plan is to uncrate and go through a successful inspection.

This means we need both sets of bumpers, we shipped one. We need the hardware/stantions to remount the top polycarbonate shield and camera.

Do were know where those pieces are?

I want to make some new lower yellow bar pieces. I was thinking on just coating a couple of times, maybe 3 with the yellow stuff. I also thought about if there was
some way to use UBO2 on the lower bar.

Fred

So, what do we need to do to get ready for the championship?

I think we can work some next week.

freds wrote:I think we can work some next week.

We'd need to awake Mrs. Rutland from her slumber.

But...Uh..the things that sticks out the most are

- Window Motor (Probably should create a new mount)
- New Backing System(The switch works well, sometimes. It requires insatiable amounts of tweaking. I'm thinking that we should return the backing plate to its original length (meaning that I think that the backing plate became finiky after we cut off that one inch from the bottom)).

I agree that we need to make so more bottom bars perhaps following the instructions on the can and waiting 24 hours for coats.

-Tanner